Shit ton of tools needed at the bottom of the steps. Good Luck!
Clean tube (optional)
Drill cap hole
Countersink washer
Assemble cap
Assemble stash
Mark and drill pilot hole
Counterbore door
Drill and shape opening
Use it!
Tools
Adhesive , thread-lock
Bowl , stainless steel, small
Countersink
Drill
Drill bit , 1″ spade
Drill bit , 1/4″ brad point
Drill bit , 1/8″ brad point
Drill bit , 3/4″ spade
File , round “rat-tail”
Goof Off (50 mL)
Hammer
Nails (3) , small
Rubber gloves
Scotch Brite pad
Scrap of wood
Thumbtack Work gloves
Relevant Parts
Washer , Flat, 1″ OD, 3/16″ ID
Washer , Flat, 1/2″ OD, 3/16″ ID
Washer , Split, 3/16″ ID
Machine screw , small flat head head should be 1/4″ diameter, total length about 1/2″
Nut , hex threaded to fit machine screw
Cigar tube , aluminum, 3/4″ OD, 6″ length
Yeah… that’s a lot of shit. Good luck!